Viking Range Designer Series Installation Guide Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
5
PPRREEPPAARRIINNGG FFOORR HHOOOODD IINNSSTTAALLLLAATTIIOONN
Plan where the ductwork will be located. See pages 8-11 for rough-in dimensions. Install proper-sized duct work, and
roof or wall cap for the type of blower you are using. Recommended hood locations for the most common
installations are shown on page 2.
Adjust your measurements for various heights of ceilings, soffits,
cabinets, or ranges/rangetops.
Roof Cap
7” Round
Duct
Roof Cap
10”
Round
duct
Duct Cover
or Soffit
Duct Cover
or Soffit
300 or 600 CFM
Interior-Power - Typical Ductwork
1200 CFM
Interior-Power - Typical Ductwork
Exterior Blower
10” Round
Duct
Duct
Cover
or Soffit
12”
(30.5 cm)
900, 1200, or 1500 CFM
Exterior-Power - Typical Ductwork
12”
(30.5 cm)
IINNSSTTAALLLLIINNGG HHOOOODD CCAANNOOPPYY
Center the wood strip (acquired locally - see drawing for dimensions) and attach to wall. Using the slot located on
the backside of the canopy, place the hood onto the wood strip. Secure the hood to strip with mounting screws
provided. Make sure that the wood strip mounting screws are driven into the framing and not just the drywall. Use
additional mounting screws (and wall anchors if necessary) in the other holes.
NNOOTTEE:: BBEECCAAUUSSEE OOFF
TTHHEE WWEEIIGGHHTT OOFF TTHHEE
HHOOOODD -- MMAAKKEE SSUURREE
TTHHAATT TTHHEE WWOOOODD SSTTRRIIPP
MMOOUUNNTTIINNGG SSCCRREEWWSS
AARREE DDRRIIVVEENN IINNTTOO TTHHEE
FFRRAAMMIINNGG AANNDD NNOOTT
JJUUSSTT TTHHEE DDRRYYWWAALLLL.. IITT
MMAAYY BBEE NNEECCEESSSSAARRYY TTOO
DDRRIILLLL AADDDDIITTIIOONNAALL
HHOOLLEESS IINN TTHHEE C
CAANNOOPPYY
FFOORR PPRROOPPEERR
AALLIIGGNNMMEENNTT..
EELLEECCTTRRIICCAALL SSUUPPPPLLYY
Run 120 VAC electrical power cable from service panel to installation location. See “Basic Specifications” on page 13
for the maximum amp requirements.
Top
Mounting
Holes
Wood Strip
(acquired locally- 1
1
/2” x
3
/4”)
Slot for Wood
Strip
Rear Mounting
Holes
1
1
/
2”
(3.8 cm)
3
/4”(1.9 cm)
1
13
/16”
(4.6 cm)
Page view 4
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments