Viking Range Designer Series Installation Guide download pdf (Page 7)

IINNSSTTAALLLLIINNGG TTHHEE VVEENNTTIILLAATTOORRSS

VVIIVV330000 oorr VVIIVV660000 -- IInntteerriioorr--PPoowweerr VVeennttiillaattoorr KKiitt ((330000 oorr 660000 CCFFMM))

(also see instructions supplied with ventilator kit)

1. Make sure barrel nuts and wing nut are engaged halfway onto

threaded stud.

2. Lift ventilator into canopy - may be easier to turn

ventilator side ways to lift into canopy then rotate

into mounting position.

3. Lift ventilator allowing barrel nuts to come

through large end of keyhole opening.

4. Slide ventilator to the right, engaging barrel

nuts into small end of keyhole openings and

engaging studs with wing nut in slot on right side

of ventilator. Make sure discharge openings

match.

5. Tighten barrel nuts and wing nut.

6. Plug the ventilator power cord into the receptacle

located on the topside of the light panel.

600 CFM Blower

Rough-in

Plate

Studs

Barrel Nuts

Top of Hood

Wingnut

Remove rear filter support before installing

blower. After installation is complete,

reinstall the rear filter support.

VVIIVV11220000 -- IInntteerriioorr--PPoowweerr VVeennttiillaattoorr KKiitt ((11220000 CCFFMM))

(also see instructions supplied with ventilator kit)

1. Make sure barrel nuts and wing nut are engaged

halfway onto threaded stud.

2. Lift ventilator into canopy - may be easier to turn

ventilator side ways to lift into canopy then rotate into

mounting position.

3. Engage tab on ventilator with slot in rough-in plate

AND engage slot in ventilator with barrel nut on

threaded stud.

4. Push ventilator towards the back of hood to fully

engage.

5. Use a long, flat-head screwdriver to tighten the barrel

nut securely.

6. Plug the ventilator power cord into the receptacle

located on the topside of the light panel.

1200 CFM Blower

Top of

Hood

Slot

Rough-in Plate

Studs

Barrel Nut

Transition

9”

(22.9 cm)

Remove rear filter support before

installing blower. After installation

is complete, reinstall the rear filter

support.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Viking Range Designer Series Installation Guide Page 7

Comments to this Manuals

Related products and manuals for Trash Compactor Viking Range Designer Series